1. Home
  2. petroleum engineering project topics ppt

Tag: petroleum engineering project topics ppt

Comparative Study Between Overbalanced And Underbalanced Oil Drilling Methods – complete project material

ABSTRACTThe technique used worldwide while drilling is known as overbalanced drilling. Which is defined as the drilling process where the hydrostatic pressure used exceeds the formation pressure. This is done with the main purpose of…

Read More

Analysis Of Void Fraction Phase Distribution Of Gas-Liquid Flow In A Horizontal Pipe Using Wire Mesh Sensor Data – complete project material

ABSTRACT The scope of this work was to make detailed analysis of phase distribution in a horizontal pipe. This detailed analysis has been successfully carried out. Data obtained from wire mesh sensor (WMS) were used…

Read More

Development Of Coning Correlations For Oil Rim Reservoirs Using Experimental Design And Response Surface Methodology – complete project material

ABSTRACT Proper management of thin oil rim reservoirs is required to maximize recovery and minimizes coning tendencies. The objective of this study is to determine the effect of reservoir and fluid properties on coning tendencies…

Read More

Experimental Investigation Of Sp Flooding In Central Onshore Of The Niger Delta – A Case Study Of Reservoir-X – complete project material

Petroleum Engineering Research project Topic Chapter 1-5 titled, Experimental Investigation Of Sp Flooding In Central Onshore Of The Niger Delta – A Case Study Of Reservoir-X. TABLE OF CONTENT   TITLE PAGE CERTIFICATION DEDICATION ACKNOWLEDGEMENT…

Read More

An Assessment Of Gravel Packing Methods Used In The Petroleum Industry – complete project material

CHAPTER ONE INTRODUCTION Many reservoirs are comprised of relatively young sediments, which are so poorly consolidated that sand will be produced along with the reservoir fluids unless the production rate is reduced significantly. Sand production…

Read More

Application Of Minimum Curvature Method To Wellpath Calculations – complete project material

ABSTRACT A major drawback of directional and horizontal well drilling is the numerous complex computations required to be done while planning a well. These computations are very stressful and time consuming especially when done manually.…

Read More

Development Of Generalized Well Semi-Analytical Coning Models – complete project material

ABSTRACT Oil deposits are often found in association with a communicating gas or water zone. The production of the oil often leads to the coning of water or gas. This dynamic interaction can be captured…

Read More

Investigation Into Pipeline Vandalism – complete project material

CHAPTER ONE 1.0           INTRODUCTION The Nigerian petroleum industry which has majority of its establishment within the Niger Delta Region has been confronted by two sapping challenges over the years. The challenges relates to the prevalence…

Read More

Gas Lift Optimization Of Oil Producing Wells Using Prosper Nodal Analysis – complete project material

Introduction Hydrocarbons(oil and gas) are found in the pore spaces of sedimentary geologic formations (reservoir rocks).  Once an oil or gas reservoir is discovered and assessed, production engineers begin the task of maximizing the amount…

Read More

A-Three Dimensional Numerical Simulator For Expansion-Drive Reservoirs – complete project material

ABSTRACT Every simulation study is a unique process, starting from the geological model and reservoir description to the final analysis of recovery factor optimizations. In petroleum engineering area, numerical reservoir simulators are often employed to…

Read More
Translate »